This is a good winter project build. It is a Bruce Gordon tig-welded touring frame and fork set. Mr. Gordon is a highly skilled and well established American frame builder. Here is a link to his website where you can read about his history and see his work Bruce Gordon Cycles. He is mostly known for his lugged construction bikes, but he is one of the best when it comes to tig-welded frames in my opinion.
     this frame has one or two issues. one of the rear brake cable stops has some corrosion around it, nothing fatal, just some rust (see photo). Also, the underside of the top tube has corrosion along the length. again, nothing fatal, but it is there (see photo). The tube could be replaced if one was so inclined, but I think it will be OK.  Frame and fork are sold AS IS. That being said, here are the measurements:

  • 47 CM seat tube CTC
  • 54CM top tube CTC
  • 135mm rear spacing
  • English threaded BB shell
  • takes 26.8mm seat post
  • 700C wheel size
  • cantilever studs front and rear
  • 28 1/2″ stand over height (at seat tube), 30″ stand over height (at head tube) no air in tires or headset installed.
  • Lots of braze-ons for fenders, water bottles and low rider racks on the fork. 
  • Serial number is G05293 I talked to Bruce Gordon and he told me the frame was built in 1993.

     Dark grey paint with original Bruce Gordon decals.  Set it up as a touring bike or swanky single speed city bike with a chain tensioner. Frame has vertical rear drop outs, fenders, racks, the whole nine yards! I think this would make a great around town TCB bike!
                                                             Cost is $275.00 plus S/H 

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s